ALLIGATOR CLIP TEST LEAD ADAPTOR  -  An adaptor that fits on the pin tips on test leads. Very convenient for hooking to to a connection without having to hold the lead with your finger. Minimizes potential for shock and insures a good connection. $5 for a pair, postpaid.


AMMETER ADAPTOR - Used for measuring AC amperage drawn by a radio under test.  Use with your normal VOM, VTVM that isn't capable of measuring AC Amps.  Installed in a Navy Blue minibox, radio plugs directly into the box and the box plugs into the AC source.  Two terminals where your meter plugs in.  Reads 0-1 Amp AC, Fused.  $12.50

ANTENNA or GROUND WINDOW FEEDTHRU - 9-3/4" long, made of .021 copper, low inductance, terminated with phosphor bronze friction clip at each end.  Insulation consists of PVC along the entire length.  Goes under the window, just close the window on it.  $5.00, postpaid.



MY LATEST PRODUCT IS THE "SLO-START" KIT, a slow turn on device combined with an AC ammeter.    The "Slo-Start"starts at 60-70 volts and ends up at about 10% less than the incoming line voltage after 90 seconds or so - a great feature when working on old radios.   The amperage is read on a separate meter on the lowest scale equating to 1 volt=1 amp.  The unit is fused at 1.25 amperes and a spare fuse is included.  The cost is $21.00 POSTPAID, about half of what other units sell for even without the ammeter option.



       
BATTERY POWER SUPPLY -  7 1/2"  X 4" X 2/12".  Black corrugated box with Black PVC reinforcements inside and out.  Brass terminals throughout with knurled nuts on the terminals.  28V,. 54V, 90V B+ and 1.50V (2.6 aH) filament batteries are in a Keystone holder for ease of replacement.  Batteries ARE included and are Walgreens brand. - $28.00 POSTPAID .



BATTERY FOR ZENITH TRANSOCEANIC - Universal type that fits all tube type T/O sets, all Hallicrafters, Stromberg-Carlson, RCA Stratoworld, Silvertone, Airline, Roland and others of similar description.  Size 10 x 4 x 2.  Has a brass connector mounted in a black expanded PVC mount.  Pins are level with the outside of the white box.  Comes complete with 10 Walgreens 9v batteries for the B supply and 6 Walgreens 1.5v batteries in D-cell holders for the A supply. - $42.00 - Available with Energizer Alkaline batteries at $55.

 Kit containing a box prepunched with all holes, terminal board, holders for 6 "D" cells, all leads, connectors for 10 "9 volt"  batteries, tape for holding batteries. - $23.00

Brass connector with black PVC mount - $10.00 when bought separately.

BRASS DIAL CABLE - For Radiola 17, etc.  Three feet for $3.00

BUMPER STICKER - "I Collect Antique Radios" with a space for a phone number - $2.00
CLEANER - Bill's famous SHIP-SHAPE cleaner/degreaser concentrate. $2.00 for a package to mix One Quart.

COIL FORM - Cardboard, 1/4" dia., 1-1/2 long, clip mount to chassis, two terminals, slug tuned.  New stock. - $1.00

COIL FORM - Plastic, 1/4" dia. 1-1/8" long, clip mount to chassis, 4 terminals, slug with 6-32 extension.  With 2 existing pi coils that are easily removed.  New stock. -$1.00

COIL FORMS - Ceramic & Plastic, 2 and 4 terminals.  7/16" dia, 5/8" long.  PC mount.  New stock. - $1.00

   "CEASE & DESIST" CONTACT CLEANER -  My latest find is a super contact cleaner for copper and brass contacts that you can mix at home.  It consists of OLEIC ACID mixed with standard Coleman Fuel.  Oleic acid is an organic acid found in things like cocoa and olive oil and not considered dangerous.  It is used for many things in industry ranging from lubricants to cosmetics to food flavorings.
My recommended mix with the Coleman fuel (naptha) or regular lighter fluid is 5%.  You may also add acetone to speed up the drying time.  Due to shipping restictions I cannot supply the fuel but I make the oleic acid available for you to make up a one quart supply.  Try it, I'm sure you will be surprised. - $8.00 Postpaid.
MSDS link here
CONTACT CLEANER ADAPTER - This is a custom-made device that can be screwed onto the front bushing of a sealed pot to inject contact cleaner - $8.00

CONTACT CLEANER SPRAY BOTTLE - I also have available a plastic spray bottle that will hold up to 250 ml of the contact cleaner mixture.  It is unique in that it has a very fine stream, perfect for application of the cleaner.  It is small and fits nicely into tight places.  If you can't find your own locally then this might be ideal - $2.00

CRYSTAL - 10.7 MHz that can be used in RCA or other signal generators - $4.00

CRYSTAL COVER - fits all crystal sets.  Domed Glass, similar to the old Philmore, etc. brands.  Available in two sizes - 1" x 1-1/4" and 1" x 1-1/2", please specify which  - $8.00

CROSLEY - Reproduction dial for the 5-50, A-07, etc.  Reproduced by computer, exactly as original down to the detail about the part number and where to buy them. (Part No. B 2293-223)  Three copies for $3.00


DIAL CORD - Woven regular cord - 20 feet for $1.50

DIAL CORD - Heavier type - 20 feet for $2.00

DIAL CORD ROSIN MIX - A four ounce bottle for improving dial cord traction.  - $8.00


DIAL SPRINGS -  I have 1-1/2"long phono springs.  These can be cut in half and bent as needed to make good dial cord tension springs.  10 for $2.50, makes 20 dial springs.

DIODES - Germanium type for crystal radios - 20 for $2.00

DIODES - 1N4007, 1A, 1000PIV silicon rectifier.  Ideal for replacing selenium rectifiers - 10 for $2.00

DIODES -  1N3595, 150 V, .200mA.  Perfect for AC/DC radios - 20 for $1.50

DIODES - 1N4749A Zener, 24 volt, 1 W.  Perfect! - 10 for $1.50

DIODE PROJECT -  FM Crystal Set Kit, everything but the headphones, all parts and a copy of the magazine it appeared in - $5.00.

FUSE HOLDER/FUSE -  1 Amp AGC fuse included.  Mounts in 0.56" hole, extends  1.65" behind panel. - $1.50

IF or RF XFMR SUBSTITUTE - Module can be hidden from sight, specify type - $4.00

LACING CABLE - lacing twine used to lace a bundle of wires.  Instructions included - 25ft for $1.50

LINE CORD - Brown, braided cloth type for vintage radios - 6' for $5.00

PANEL - Made of 1/4" black PVC. Easier to work than Plexiglas or Bakelite.  Very similar in appearance to old antique radio panels - Available in 6" x 24" or 12"x 12" at $12.00 per sq ft.
PERIKON DETECTORS for Radiola V receivers.  They have fluted sides and a finish that matches the originals.  They have zincite in the movable cup and bornite in the fixed, both are attached in the cup with "Woods Metal".  - $50.00 for the pair.

PILOT LAMP  - Colored with red, green, blue or amber.  You supply the bulb - $2.00 each

PLUG - Antique style, flat Bakelite type for AC cords.  Brown or white - $1.50

POWER SUPPLY  KIT - AC operated, includes transformer, diode rectifier, 2-section electrolytic, zener regulator.  Choice of 45, 67 or 90 volts DEC output @ 40ma.  $19.00

As above for 9 volts @ 100 ma.  $17.00


PUSH PINS FOR RADIO BACKS - Metal, painted shiny black.  Domed head, compression legs 1/2"long.  Replaces any type.  Package of 8 for $3.00.

RADIOLA III, III-A, RA/DA and DA - Shock mount material.  Enough for three tubes - $2.00


RADIOLA V -  I have the screws with the GE logo on top, either the short for the crystal or the long for the tension adjustment, - $10.00 each

RADIOLA V - Spring, made of .020 phosphor bronze.  Formed and drilled just like the original.  Perfect match for the Perikon crystals and screws listed elsewhere - $15.00

REGENERATIVE RADIO KIT - Would you (or your kids or grandkids) like to "return to the thrilling days of yesteryear?" Here is a kit with everything you need to build a Regenerative Radio -  tube socket, tube, regeneration control,  wire, hookup wire, knobs, grid leak and capacitor, all screws, terminal strip, etc. You will need to provide headphones,  a "D" cell and five "9 volt" transistor batteries to make it work. This is a duplicate of one I built from a Magazine Article in 1947. Includes a copy of the original Article - $38.95

The original Article included an amplifier following the detector. This is the tube, tube socket, plate load resistor, coupling capacitor and the grid resistor to add the second stage. It really makes a difference in the volume. Will run a speaker (with output transformer) on local stations. Build it with the radio or add it later - $12.00.

ROTTENSTONE - with application felt - $3.00

SCREWS, BRASS -  #1 x 1/4" with round head - 12 for $2.00

SHAFT EXTENSION - 1/4"x 6" - $1.50

SPRINGS -   see DIAL SPRINGS above

SWITCH POINTS AND MASTER - For antique radios and homebrew projects.  NOS. 6 for $10.00

TERMINAL STRIPS - For antenna, speaker, etc.  Two each of 2 or 5 terminals -  $2.00          

VARIABLE CAPACITOR - A high quality Asian-made 250pf model.  1/4" shaft, use 2 in parallel for a crystal set with bandspread! - $10.00 each.


VARIABLE CAPACITOR - Asian-made 50pf.  $15.00

WIRE - Hookup wire, 22 ga, tinned with PVC jacket, tinned.  Green or black.  100 feet @  $2.50

WIRE for COILS -  24 ga enamelled available. - Quarter-pound roll for $5.00


WOODEN BASE -  A solid walnut block 4 x 6 inches x 3/4" thick with chamfered edge.  Green felt supplied for the bottom.  You finish sand, and coat one or two times with Watco Danish Oil or Deft Clear Wood Finish.  Dries in about 30 Minutes.  Coat bottom with Elmer's glue and place on felt.  When dry trim felt to size.  Use as a base for 1 or 2 display  tubes, a crystal detector, wave trap or anything you might want to mount.  $10.00 postpaid.